This is a quick installation guide, for a more detailed guide please read the other articles.
Before starting the setup, unbox and unpack everything make sure you have the main unit, the batteries and the sensor units at arms length.
Take the main unit remove the screw and slide the back cover. Insert the SIM card and plug in the supplied 9V battery as shown in following diagram.
Plug the power adapter into the wall socket and afterwards into the main unit as shown.
If everything is done correctly the Power LED will have a steady green color.
When the SIM has made a connection to the network the Signal LED will have a steady green color.
Change the default password
The default password is 1234. Change the default password by typing on the numpad the following code:
*#→password→00->new password*→new password→Func Key
For example to change the password from the default 1234 to 4567 do the following.
On the numpad:
Type:
*#1234004567*4567
Press:
The main unit will now beep two times to confirm that the change was made and the password will be changed to 4567.
Add a sensor unit
To add motion sensors to the AG50 please follow the instructions below. Up to 64 Motion sensors
can be added across 4 zones.
Insert the following code:
*#→password→71→Func Key Trigger the sensor that you want to put in zone1
Trigger the motion sensor by connecting the battery.
Example
On the numpad:
Type:
*#456771
Press:
Trigger the sensor by connecting the battery:
The status LED’s will light as following:
After the Setting/Register LED and Zone1 LED’s have turned off, this means that the sensor has been added and is active in Zone1.
Adding a SMS number
When your alarm is triggered in any zone, you can choose to send an SMS to up to 3 numbers. To add the SMS numbers into your main unit input the following code:
*#→password→11→SMS Num.1*→SMS Num.1→Func Key
Example
On the numpad:
Type:
*#4567110754341965*0754341965
Press:
If the code is correct and the operation is successful the main unit will make 2 short sounds. The number 0754341965 will be added in the memory of the main unit and a SMS will be sent to it when an alarm is triggered.
Arming the Vonino Axesstel AG50
To activate Siren mode enter the following:
*#→password→01->Arming Key
Example:
On the numpad:
Type:
*#456701
Press:
The status LED’s will change to the following:
The Vonino Axesstel system is now armed and operational.
If the alarm is triggered the status LED’s will change to the following:
The main unit will send a SMS to the predefined numbers.
Disarming the Vonino Axesstel AG50
To disarm the AG50 in a normal manner enter the following:
*#->password->05->Arming Key Normal disarming
Example:
On the numpad:
Type:
*#456705
Press:
The alarm is now disarmed.